HP Comware 5 Debug Manual Vol 2

Table 191 Output from the debugging isis interface-information command
Field
Description
CIRC: MTU Size Exceeds Max PDU Size mtuSize,
Setting it to Max PDU Size.
The interface MTU exceeds the maximum PDU size.
The interface MTU is being set to the maximum PDU
size.
IF: Disable ip route isis Failed IS-IS failed to disable IP routing on the interface.
IF:Can't get the interface index IS-IS cannot obtain the interface index.
IF:Can't get the interface type IS-IS cannot obtain the interface type.
ISIS interface IPV4/V6 Addr nums exceed array
maxnum
The number of IPv4/IPv6 IP addresses on the interface
has exceeded the upper limit.
T a b l e 11 describes output fields and messages for the debugging isis non-stop-routing command.
Table 192 Output from the debugging isis non-stop-routing command
Field
Description
ISIS-procId-NSR_EVE: Entering NsrPhase Status.
IS-IS NSR status debugging information:
NsrPhase—NSR status ID, including:
• NSR_PHASE_ENTER—Enters the NSR status.
• NSR_PHASE_SMOOTH_ADJ—Starts recovering
adjacency information.
• NSR_PHASE_SMOOTH_LSP_OVER—Completes
recovering LSPs received from other systems.
• NSR_PHASE_LEAVE—Leaves the NSR status.
• NSR_PHASE_FLUSH_LSP—Begins to generate local
LSPs and age LSPs.
• NSR_PHASE_FLUSH_ROUTE_OVER—Completes
deleting and aging routes.
• NSR_PHASE_COMPLETE—Completes NSR status.
• NSR_PHASE_INVALID—Invalid NSR status.
ISIS-procId-NSR_EVE: Begin to backup levelType
datatype.
NSR begins to backup certain type of data.
• levelType—Data level, Level-1 or Level-2.
• Datatype—Data type, including:
 Local ISPs.
 Non-local LSPs.
 Route prefixes.
ISIS-procId-NSR_EVE: End to backup levelType
datatype.
NSR completes backing up certain type of data.
• levelType—Data level, Level-1 or Level-2.
• Datatype—Data type, including:
 Local ISPs.
 Non-local LSPs.
 Route prefixes.
ISIS-procId-NSR_EVE: Begin to smooth enable
levelType adjacency.
NSR starts recovering adjacency information.
levelType indicates the neighbor level, Level-1 and
Level-2.
278