HP Comware 5 Debug Manual Vol 2

Field
Description
Rxed pduType From sourceId (circuitName)
IS-IS received PDUs.
• pduType—PDU type: PSNP or CSNP.
• sourceId—Source NSAP address of the packet.
• circuitName—Name of the receiving interface.
SNP PDU Dropped SNP PDU was dropped.
Sending Level pduLevel PSNP PDU fails
IS-IS failed to send a PSNP packet.
pduLevel indicates the PDU packet level: L1 or L2.
Sending content on circuitName
IS-IS is sending a PSNP packet.
• circuitName—Name of the sending interface.
• content—PSNP packet content.
SNP not processed, System in Low Memory
System memory was insufficient and the SNP packets
were not processed.
SNP not processed, System in Overload State (Low
Memory).
The system is in the Overload state and the SNP
packets were not processed.
Psnp not processed, current IS is Not DIS
The current IS was not a DIS and the received PSNP
packet was not processed.
Csnp not processed on DIS The CSNP packet was not processed on the DIS.
SNP Authentication Failure SNP authentication failed.
Sending pduLevel CSNP PDU fails
IS-IS failed to send CSNP packets.
pduLevel: PDU packet level: L1 or L2.
Sending CSNP on P2P Interface circuitName
IS-IS is sending a CSNP packet through the P2P
interface.
Failed to Send CSNP PDU IS-IS failed to send a CSNP PDU.
Sending content on circuitName
IS-IS is sending a CSNP PDU.
• circuitName—Name of the sending interface.
• content—CSNP packet content.
Tab l e 16 describes output fields and messages for the debugging isis traffic-eng command.
Table 197 Output from the debugging isis traffic-eng command
Field
Description
Received Extended IS Reach information from LSP
IS-IS received an LSP with the TLV of an extended
reachable address.
TE: Get TE Info for Circuit %s Failed in Circ Enable
Tunnel interface has been disabled. Tunnel interface
information was not obtained.
TE: Add If Te info failed IS-IS failed to add TE interface information.
TE: Rm Traffic Engineering change status to enable RM TE status changes to "enabled."
TE: ISIS Update Te LinkInfo In Local TeDb
IS-IS updates TE link information in the local TE
database.
Tab l e 17 describes output fields and messages for the debugging isis update-packet command.
281