HP Comware 5 Debug Manual Vol 2

Table 198 Output from the debugging isis update-packet command
Field
Description
pdu length: pduLen Length of received PDU.
Adjacency Usage: adjType Adjacency type.
Fast Flood levelType LSP before SPF
LSPs are fast-flooded before SPF calculation.
levelType: LSP level: L1 or L2.
RECV: Rxed IS-IS PDU of pduLen which is greater than
receive size(receiveLen)
IS-IS received a PDU with a pduLen greater than
receive size (receiveLen).
Err!Lsp fragment exceeding Max limit !!! LSP fragment number exceeds the maximum limit.
UPDT: Circuit up failed IS-IS failed to bring up the interface.
UPDT: Circuit not brought down IS-IS failed to bring down the interface.
UPDT: Error! Txmission of Csnp on P2Pckt failed
Transmission of CSNP packets on a P2P network
failed.
UPDT: Rx Man area change The area address in the received LSP changed.
UPDT: Err! Zero Lsp Desc not present Error! Zero LSP fragment is not present.
UPDT: Err, Match not found for the area addr option
No match was located for the area address in the L1
LSP.
UPDT: Rx att flag change ATT flag changed in the received LSP.
UPDT: Fatal! Failed to flood Lsp with oload bit set IS-IS failed to flood the LSP because overload bit is set.
UPDT: LSDB Enters Normal Over Load State The LSDB enters the overloaded state.
UPDT: update process recovered from Normal
Oload !
The LSDB leaves the overloaded state.
UPDT: Rx IP change from config IP reachable TLV in the received LSP changed.
UPDT: v4/v6 Default Info Origination Denied by
Policy
Default route information failed to pass the policy and
was not sent in an LSP.
UPDT: Default Info Origination Permited by Policy
Default route information passed the policy and was
sent in an LSP.
UPDT: Adj Up failed IS-IS failed to bring up the adjacency.
UPDT: Err1 Processing of Adj down not successful !.
SysType sysLevel Usage adjType
The L1/L2/L12 system failed to process the
L1/L2/L12 adjacency down event.
UPDT: Learnt Area Addr change The area address in the received LSP changed.
UPDT: MinLspGen Timer hasn't expired. Not
generating Lsp
The minimum LSP generation interval has not expired,
so no new LSPs can be generated.
UPDT: Err! Unexpected Level levelType
The type of the received LSP is invalid.
levelType: LSP level, L1 or L2.
UPDT: Lsp with Invalid IS Nbr Id The received LSP has an invalid neighbor system ID.
UPDT: Max Area Mismatch
The maximum area address number in the received
LSP does not match that of the current device.
UPDT: Invalid LSP specific hdr ! Invalid received LSP packet header.
282