HP Comware 5 Debug Manual Vol 2

Table 213 Output from the debugging pad event command
Field
Description
PAD: start clear procedure The clearing procedures started.
PAD: Fragment and ReEnqueue the MBUF X.25 fragments and enqueues the MBUF.
PAD: Parameter is negotiatory Parameter negotiation is being performed.
PAD: Parameter negotiatory end Parameter negotiation is completed.
PADX Closed by Line PAD closes the PADX link. X is the PAD ID.
Table 7 describes the output fields and messages for the debugging pad packet command.
Table 214 Output from the debugging pad packet command
Field
Description
PAD Module name.
pad-num PAD control block ID.
Receive a user data packet A user data packet was received.
Send a user data packet A user data packet was sent.
Length Packet length.
Receive a control packet A control packet was received.
Send a control packet A control packet was sent.
packet-type-description Packet type description.
X.3 parameter is X.3 parameters.
Examples
CAUTION:
During a PAD session, the console sends the operation information character by character. If X.25 packet
or PAD packet debugging is enabled, the output might be
excessive and affect the operations on the
console.
# Enable debugging for PAD packets. Output similar to the following example is generated when you
log in to Router B from Router A by using PAD under the following conditions:
•
Router A and Router B are connected.
•
The configuration on Router A is as follows:
<RouterA> display current-configuration interface serial 2/0
#
interface Serial2/0
link-protocol x25 dce
x25 x121-address 1
#
return
•
The configuration on Router B is as follows:
[RouterB] display current-configuration
311