HP Comware 5 Debug Manual Vol 2

Field
Description
S2/0 X.25 LCI 1024: Called address != local address
The called number of the VC with LCI 1024 is not a
local address.
DXE can not accept call( incorrect channel )
DXE cannot accept a call because the call uses an
incorrect channel.
CUG number error, forbid call in
CUG number is incorrect and incoming calls are
denied.
CUG number error, forbid call out
CUG number is incorrect and outgoing calls are
denied.
Not configured to accept reverse charging facility
Reverse charging is not configured on the local
interface.
Input packet's GFI is invalid
The general format identifier (GFI) of the incoming
packets is invalid.
Sequence number of input packet is error Incoming packet sequence number error.
Input packet is too short
Input packet length is less than the minimum
allowed.
Unknown protocol type Unknown protocol type.
Fragments are too many
The number of the fragments received exceeds the
maximum allowed.
Bad protocol type of call in packet
The protocol type of the incoming call packets is
invalid.
Facility error in call in packet The facility of the incoming call packets is invalid.
Call in packet is too short
Call packet length is less than the minimum
allowed.
Error! Fail to fragment MBUF X25 failed to fragment MBUF.
Output queue has been full The output queue is full.
Fail to send data packet X25 failed to send data packets.
Protocol address is not mapped The map of the protocol address is not found.
Sub interface is down! Cannot send packet
Packets cannot be sent because the sub-interface is
down.
Can not transmit in current state
X25 cannot transmit packets through the VC in its
current state.
Fail to add new hash node
X25 failed to register a VC with the interface
control block.
Table 9 describes the output fields and messages for the debugging x25 event command.
Table 216 Output from the debugging x25 event command
Field
Description
Start restart timer The restart timer Tx0 was triggered.
Stop restart timer The restart timer Tx0 was stopped.
Start call timer The call timer Tx1 was triggered.
314