HP Comware 5 Debug Manual Vol 2

Field
Description
Stop call timer The call timer Tx1 was stopped.
Start reset timer The reset timer Tx2 was triggered.
Stop reset timer The reset timer Tx2 was stopped.
Start clear timer The clear timer Tx3 was triggered.
Stop clear timer The clear timer Tx3 was stopped.
Start idle timer The idle timer was triggered.
Stop idle timer The idle timer was stopped.
Start dellcd timer The DelLCD timer was triggered.
Stop dellcd timer The DelLCD timer was stopped.
XXX timer time out XXX timer timed out.
VOFR FR_X25_EncapRFC1294: X25 Encap RFC1294
Succeed
Packets were encapsulated successfully using VOFR
X25 RFC1294 standard.
VOFR FR_X25_EncapRFC1294: packet type is not
supported by Annex G
Packet type is not supported by Annex G.
Table 10 describes the output fields and messages for the debugging x25 packet command.
Table 217 Output from the debugging x25 packet command
Field
Description
[ XOT-VC ] [ XOT virtual circuit ].
interface-name Interface name.
X25 Module name.
direction
Frame direction, which can be I (incoming) or O
(outgoing).
State state Virtual circuit state.
LCI lcd-num Virtual circuit ID.
MOD modulo Modulo.
call-packet-type Call packet type.
packet-type Packet type.
Ps ps Sending sequence number.
Pr pr Receiving sequence number.
LEN packet-length Packet length.
Examples
# Enable debugging for X.25 packets. Output similar to the following example is generated when you
ping Router B from Router A under the following conditions:
•
Router A and Router B are connected.
•
The configuration on Router A is as follows:
<RouterA> display current-configuration interface Serial 2/0
315