HP Comware 5 Debug Manual Vol 2

1 packet(s) transmitted
1 packet(s) received
0.00% packet loss
round-trip min/avg/max = 6/6/6 ms
// Router A received the ping response from Router B.
debugging x25 x2t
Use debugging x25 x2t to enable X2T debugging.
Use undo debugging x25 x2t to disable X2T debugging.
Syntax
debugging x25 x2t { all | event | packet }
undo debugging x25 x2t { all | event | packet }
Default
All types of X2T debugging are disabled.
Views
User view
Default command level
1: Monitor level
Parameters
all: All types of X2T (X.25 to TCP switch) debugging.
event: Debugging for X2T events.
packet: Debugging for X2T packets.
Usage guidelines
T a b l e 11 describes the output fields and messages for the debugging x25 x2t event command.
Table 218 Output from the debugging x25 x2t event command
Field
Description
X2T: Not found %s configuration entry X25 failed to find an X2T configuration entry.
X2T: Send a X2T_CLOSE_SOCKET message when
deleting configuration
X25 sent a socket close message when removing an
X2T configuration entry.
X2T: Get a wrong configuration control message
The type of the received configuration message is
invalid.
IP: ip-address Port: port-num accept a tcp socket.
SocketID=socket-id
A socket connection was received on the IP side.
Connect to Server IP: ip-address Port: port-num
X25 tried to establish a socket connection to the IP
side.
Fail to Connect to Server IP: ip-address Port: port-num
X25 failed to establish a socket connection to the IP
side.
X2T: Listen on the New Socket IP: ip-address Port:
port-num
X2T started to listen to a new port (port-num) on the IP
(ip-address).
317