HP Comware 5 Debug Manual Vol 2

Field
Description
X2T: Get an error while creating a tcp socket! X25 failed to create a socket.
X2T: Get an error when accepting a tcp connection Error occurred when X25 was accepting a socket.
X2T: Fail to receive when reading true data X25 failed to read data.
X2T: Get an error when sending data to tcp X25 failed to send data.
X2T: Receive invalid packet header Packet header is invalid.
X2T: Received packet length is invalid
Packet length is invalid (less than the minimum
allowed or larger than the maximum allowed)
X2T: Get an error when creating X2tSWEntry! X25 failed to create a forwarding entry.
X2T: Send a X2T_CLOSE_SOCKET message when
deleting SWEntry
X25 send a socket closing message when removing
an X2T forwarding entry.
X2T: SWentry is not in Transfer State The link is not in the transfer state.
X2T: Get a wrong socket message The socket message received is invalid.
X2T: Get a wrong control message The control message received is invalid.
X2T: Get an error message The message received is invalid.
X2T: X2T_X25 Can not Find the X25 SwRtentry X25 failed to locate a forwarding entry.
X2T: X2T_X25 Fail to Create LCD X25 failed to create a VC.
X2T: Fail to Apply for X2T Head X25 failed to allocate memory for packet header.
X2T: X2TSwentry SendQueue is Full The output queue is full.
X2T: Send the X2T_SEND_DATA Message to the X2T
Task
X25 failed to write data sending messages to an X2T
task.
X2T: Get a wrong hot recover message The type of the hot-swappable message is invalid.
Tab l e 12 describes the output fields and messages for the debugging x25 x2t packet command.
Table 219 Output from the debugging x25 x2t packet command
Field
Description
X2T Module name.
Receive a Packet From direction X.25/TCP Packets are received.
Packet Length is packet-length Packet length.
Examples
The output in the following examples is generated when the client sends packets to the server under the
following conditions:
•
X.25 emulation client client_once 1.1.1.2 102 1 50 is run on PC 1. X.25 emulation server server_once
102 is run on PC 2. PC 1 is connected to Router A and PC 2 is connected to Router B.
•
Router A and Router B are operating as two X2T switches with X.25 between them.
•
The following operations are performed to enable PC 1 and PC 2 to communicate with each other:
 Configuration on Router A:
#
x25 switching
318