HP Comware 5 Debug Manual Vol 2

Table 1 describes the output fields and messages for the debugging fcoe error command.
Table 31 Output from the debugging fcoe error command
− Field
− Description
− Failed to check flow for a
too short period
− FCoE failed to check the
flow because the current
update time is no later than
the last update time.
Table 2 describes the output fields and messages for the debugging fcoe packet fcm command.
Table 32 Output from the debugging fcoe packet fcm command
−
Field
−
Description
− ENode MAC is not found,
and the packet was
discarded
− The MAC address of the
FCoE node (ENode) was not
found, and the packet was
dropped.
− ENode MAC is invalid, and
the packet was discarded
− The MAC address of the
ENode was invalid, and the
packet was dropped.
− ENode MAC does not
match Source MAC, and
the packet was discarded
− The MAC address of the
ENode did not match the
source MAC, and the packet
was dropped.
− Input FCoE packet to FCoE
queue successfully
− FCoE packets were
successfully assigned to the
FCoE queue.
− Failed to encapsulate the
VFT, and the packet was
discarded
− FCoE failed to encapsulate
the packet with the virtual
fiber tagging extended
header (VFT header), and
the packet was dropped.
Table 3 describes the output fields and messages for the debugging fcoe packet fip command.
Table 33 Output from the debugging fcoe packet fip command
− Field
− Description
− Descriptor Descriptor − Descriptor type:
• MAC address.
• FC-MA P.
• Name_Identifier.
• Maximum packet size.
• FLOGI.
• LOGO.
• Vx_Port.
• Priority.
• Fabric.
• FKA_ADV_Period.
45