HP Comware 5 Debug Manual Vol 2

Default command level
1: Monitor level
Parameters
tcp Specifies debugging for TCP packet filtering.
udp: Specifies debugging for UDP packet filtering.
icmp: Specifies debugging for ICMP packet filtering.
others: Specifies debugging for packet filtering of other protocols except ICMP, TCP, and UDP.
all: Specifies all types of debugging for packet filtering.
acl acl-number: Specifies an ACL for packet filtering. The acl-number argument refers to an ACL number
in the range of 2000 to 3999. You can specify this argument multiple times, but only the most recent
setting takes effect.
Usage guidelines
NOTE:
Support for this command depends on the device model.
Table 5 describes output fields and messages for the debugging firewall packet-filter icmp command.
Table 38 Output from the debugging firewall packet-filter icmp command
Field
Description
Thread Virtual CPU number.
icmp The protocol is ICMP.
from A to B The source zone is A and the destination zone is B.
Table 6 describes output fields and messages for the debugging firewall packet-filter tcp command.
Table 39 Output from the debugging firewall packet-filter tcp command
Field
Description
Thread Virtual CPU number.
tcp The protocol is TCP.
from A to B The source zone is A and the destination zone is B.
Table 7 describes output fields and messages for the debugging firewall packet-filter udp command.
Table 40 Output from the debugging firewall packet-filter udp command
Field
Description
Thread Virtual CPU number.
udp The protocol is UDP.
from A to B The source zone is A and the destination zone is B.
Examples
# Enable debugging for TCP packet filtering on the device with firewall enabled.
<Sysname> debugging firewall packet-filter tcp
*May 31 12:17:07:518 2006 Sysname DPFILTER/7/debug:
52