HP Comware 5 Debug Manual Vol 2

Table 4 describes the output fields and messages for the debugging fr mfr control command.
Table 58 Output from the debugging fr mfr control command
Field
Description
MFR msg Type of the control message sent or received on the
bundle link.
ADD_LINK The message sent to notify the remote end that the
local end can process MFR frames.
ADD_LINK_ACK The message sent to acknowledge the receipt of an
ADD_LINK message.
ADD_LINK_REJ The message sent to indicate rejection of an
ADD_LINK message.
HELLO The message sent to notify the remote end that the
local end is up. The two ends of a bundle link generate
the message periodically.
HELLO_ACK The message sent to acknowledge receipt of a HELLO
message.
REMOVE_LINK The message sent to notify the remote end of the
removal of the local bundle link from the current
bundle.
REMOVE_LINK_ACK The message sent to acknowledge receipt of the
REMOVE_LINK message.
Length Packet length.
Link Interface name of the bundle link.
BL state State of the bundle link.
E1 00 05 03 06 0E 29 A9 31 Payload of the control message.
current sequence Current sequence number of the message.
reordered sequence Re-ordered sequence number of the message.
unknown link integrity protocol control message Unknown LIV control message.
DLCI is error The DLCI of the MFR packet is incorrect.
MFR frame (Sequence No is [ulong]) is freed MFR frame with the sequence number identified by
[ulong] was dropped.
Table 5 describes the output fields and messages for the debugging fr transmit-rate command.
Table 59 Output from the debugging fr transmit-rate command
Field
Description
transmit rate is changing down to The transmission rate decreased to the specified rate.
transmit rate is changing up to The transmission rate increased to the specified rate.
Examples
CAUTION:
Be cautious when enabling frame relay debugging, because frame relay debugging will affect system
performance significantly.
67