Manualshelf

HP Comware 5 Debug Manual Vol 2

ManualsBrandsHP ManualsNetwork HardwareHP HSR6804 Router Chassis
71727374757677787980
k=Serial2/0, BL state=Up
// A message was sent to notify the remote end of receipt of the Remove_link message.
debugging fr transmit-rate
# Enable FRTS rate tuning debugging on Router A. Output similar to the following example is generated
when Router B is congested because Router A sends enormous traffic under the following conditions:
•
On a frame relay network formed by Routers A, B, and C, Router B is the switching device.
•
Congestion management is configured on the outbound interface for frame relay switching.
•
Traffic size auto-adaptation is configured on Router A.
In response to congestion, Router B sends packets with BECN bit 1 to Router A. Receiving the packet,
Router A should adjust its transmission rate.
<RouterA> debugging fr transmit-rate
*0.14214140 RouterA FR/7/debug8: RATE: Serial2/0 DLCI:100 transmit rate is changing down
to 30000
// The transmission rate decreased to 30000 bps.
*0.14214340 RouterA FR/7/debug8: RATE: Serial2/0 DLCI:100 transmit rate is changing up
to 36000
// The transmission rate increased to 36000 bps.
*0.14215940 RouterA FR/7/debug8: RATE: Serial2/0 DLCI:100 transmit rate is changing up
to 43200
// The transmission rate increased to 43200 bps.
*0.14218150 RouterA FR/7/debug8: RATE: Serial2/0 DLCI:100 transmit rate is changing up
to 51840
// The transmission rate increased to 51840 bps.
*0.14220360 RouterA FR/7/debug8: RATE: Serial2/0 DLCI:100 transmit rate is changing up
to 56000
// The transmission rate increased to 56000 bps.
debugging fr compress
Use debugging fr to enable FRF.9 STAC debugging for the specified interface or all interfaces, if no
interface is specified.
Use undo debugging fr compress to disable FRF.9 STAC debugging for the specified interface or all
interfaces, if no interface is specified.
Syntax
debugging fr compress [ interface interface-type interface-number ]
undo debugging fr compress [ interface interface-type interface-number ]
Default
FRF.9 STAC debugging is disabled.
Views
User view
Default command level
1: Monitor level
71