HP Comware 5 Debug Manual Vol 2

// An InARP request was sent out DLCI of 200 on Serial2/0.
*0.265583484 RouterA FR/7/debug8: INARP: Serial2/0 (in) reply, dlci =200
*0.265583484 RouterA FR/7/debug8: hard len = 2, hard = 0x000F
*0.265583484 RouterA FR/7/debug8: prot len = 4, prot = 0x0800
*0.265583484 RouterA FR/7/debug8: sender: 2.2.2.2, target: 2.2.2.1
// The response to the InARP request was received on DLCI of 200 on Serial2/0.
debugging fr ipc
Use debugging fr ipc to enable IPC debugging for frame relay.
Use undo debugging fr ipc to disable IPC debugging for frame relay.
Syntax
debugging fr ipc
undo debugging fr ipc
Default
IPC debugging for frame relay is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 10 describes output fields and messages for the debugging fr ipc command.
Table 64 Output from the debugging fr ipc command
Field
Description
io board Input/output (or interface) board.
main board Main control board.
cfg msg A configuration message.
rpc enq A remote procedure call (RPC) request message.
rpc reply An RPC response messages.
ipc notify An inter-process communications (IPC) message.
link-protocol fr The link layer encapsulation is frame relay.
pvc switch state update Change occurred to the PVC switching table.
interface batch removed notification Interfaces were removed in bulk.
interface deleted notification Notification indicating an interface removal.
frame congest send becn response BECN packet sent on congestion.
Examples
# Enable the IPC debugging for frame relay on Router A. Output similar to the following example is
generated when Router A and Router B are connected through FR.
<RouterA> debugging fr ipc
78