HP Comware 5 Debug Manual Vol 2

Default
GVRP state machine debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
If you do not specify a port, the command enables GVRP state machine debugging on all ports.
Table 3 describes output fields and messages for the debugging gvrp state command.
Table 72 Output from the debugging gvrp state command
Field
Description
VLAN n VLAN ID.
App = state State of the applicant state machine: VA, AA, QA, LA, VP, AP, QP, VO, AO,
QO, LO, VON, AON, or QON.
Reg = state State of the Registrar state machine: INN, LV, L3, L2, L1, MT, INR, LVR, L3R,
L2R, L1R, MTR, INF, LVF, L3F, L2F, L1F, or MTF.
Examples
# Enable GVRP state machine debugging on a GVRP-enabled device.
<Sysname> debugging gvrp state
*0.3440813 Sysname GARP/7/Gvrp state:
The GVRP state of VLAN 2 on port Ethernet1/1 is: App = VP, Reg = MTR
// On Ethernet1/1, the Applicant state machine was in VP state, and the Registrar state machine was in
MTR State.
92