HP Comware 5 Debug Manual Vol 3

Table 70 Output from the debugging mrm event command
Field
Description
(sadd, gadd) (S, G) entry.
failed Operation failed.
T a b l e 11 describes output fields and messages for the debugging mrm packet command.
Table 71 Output from the debugging mrm packet command
Field
Description
Received Received packets.
MFIB information(NOCACHE)
MFIB information(WRONGIF)
MFIB information(ACTIVE)
MFIB information(INACTIVE)
MFIB information(SPT)
MFIB information(CLEAR)
MFIB information(REG-Timeout)
Pim
packet (protocol = 2)
Types of received packets:
• MFIB information(NOCACHE)
• MFIB information(WRONGIF)
• MFIB information(ACTIVE)
• MFIB information(INACTIVE)
• MFIB information(SPT)
• MFIB information(CLEAR)
• MFIB information(REG-Timeout)
• Pim
• packet (protocol = 2)
(sadd, gadd) (S, G) entry.
Ta b l e 12 describes output fields and messages for the debugging mrm route command.
Table 72 Output from the debugging mrm route command
Field
Description
lost the route A route was deleted.
a new route A new route was added.
(sadd, gadd) (S, G) entry.
Examples
The output in the following examples was created when PIM-SM is enabled:
# Enable MRM event debugging for the public network.
<Sysname> debugging mrm event
*0.1433697 85 MRM/7/EVENT:
(public net):Task(IGMPV3) register interest in (*,235.1.1.1)(C153622)
// An IGMP join message was received and IGMPv3 created a (*, 235.1.1.1) entry.
*0.1434697 85 MRM/7/EVENT:
(public net):Task(IGMPV3) unregistered interest in (*,235.1.1.1)(C153522)
// IGMPv3 deleted the (*, 235.1.1.1) entry 130 seconds after the host stopped sending IGMP join
messages.
# Enable MRM packet debugging on the public network.
<Sysname> debugging mrm packet
95