HP Comware 5 Debug Manual Vol 3

Table 79 Output from the debugging mtunnel event command
Field
Description
The block chain is NULL The global chain of MT data block is null.
SplImp is failed The multicast tunnel failed to disable interruption.
the DrvContext[0] is 0x DrvContext[0] value of the MPU.
the DrvContext[1] is 0x DrvContext[1] value of the MPU.
the DrvContext[0] from DRV is 0x
DrvContext[0] value the MPU obtained from the
driver.
the DrvContext[1] from DRV is 0x
DrvContext[1] value the MPU obtained from the
driver.
the IO-DrvContext[0] from mainboard is 0x
DrvContext[0] value the IO card obtained from the
MPU.
the IO-DrvContext[1] from mainboard is 0x
DrvContext[1] value the IO card obtained from the
MPU.
the IO-DrvContext[0] from IOboard is 0x DrvContext[0] value of the IO card.
the IO-DrvContext[1] from IOboard is 0x DrvContext[1] value of the IO card.
the IO-DrvContext[0] from DRV is 0x
DrvContext[0] value the IO card obtained from the
driver.
the IO-DrvContext[1] from DRV is 0x
DrvContext[1] value the IO card obtained from the
driver.
Deleted link CB(if index = 0x%X)
The MT link-layer control block was successfully
deleted. (MTI index = 0x%X)
The MTunnel is not found The MTI to be deleted was not found.
the MsgRPC_CMD, send to No.1 board, is 0x%X Value of the RPC message sent to IO card 1.
the MsgRPC_CMD, Broadcast to IO board, is 0x%X Value of the RPC message broadcast to all IO cards.
No.1 board, the Recive-MsgRPC_CMD is 0x%X Value of the RPC message received on IO card 1.
No.1 board , the IO-Drv-CMD from mainboard is
0x%X
Value of driver context that IO card 1 received from
the MPU.
Table 6 describes output fields and messages for the debugging mtunnel ipc command.
Table 80 Output from the debugging mtunnel ipc command
Field
Description
Recive-Msg is NULL The received IPC message is null.
The length of receive-Msg is wrong The size of the received IPC message is incorrect.
the MsgRPC_CMD, Send to No.1 Failed(Revlen
error), is 0x%X
RPC communication with board 1 failed (incorrect
length received). The command word is 0x%X.
the MsgRPC_CMD, Send to No.1 timeout, is 0x%X
RPC communication with board 1 failed (command
timed out). The command word is 0x%X.
Alloc IPC_RPC_MSG error RPC communication failed (memory allocation error).
Table 7 describes output fields and messages for the debugging mtunnel management command.
103