HP Comware 5 Debug Manual Vol 3

Examples
# Enable MVRP event debugging.
<Sysname> debugging mvrp event
*Mar 31 17:49:26:219 2011 Sysname MVRP/7/MVRP_DEBUG: EVENT:
VLAN list successfully created when the OP timed out.
*Mar 31 17:49:26:219 2011 Sysname MVRP/7/MVRP_DEBUG: EVENT:
VLAN list added to the trunk port.
// Creating VLAN 10 on the remote interface triggered the process of adding the VLAN list on the local
interface to the trunk port.
debugging mvrp packet
Use debugging mvrp packet to enable MVRP packet debugging on an interface.
Use undo debugging mvrp packet to disable MVRP packet debugging on an interface.
Syntax
debugging mvrp packet { send | receive } interface interface-type interface-number
undo debugging mvrp packet { send | receive } interface interface-type interface-number
Default
MVRP packet debugging is disabled on an interface.
Views
User view
Default command level
1: Monitor level
Parameters
send: Specifies debugging for sent MVRP packets.
receive: Specifies debugging for received MVRP packets.
interface interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
Table 1 describes output fields and messages for the debugging mvrp packet command.
Table 83 Output from the debugging mvrp packet command
Field
Description
VLAN Attribute
VLAN state:
• New—Declared and maybe not registered.
• JoinIn—Declared and registered.
• In—Not declared but registered.
• JoinEmpty—Declared but not registered.
• Empty—Not declared or registered.
VLAN ID
VLAN ID in the range of the minimum VLAN ID to the
maximum VLAN ID that the system supports.
108