HP Comware 5 Debug Manual Vol 3

Examples
# Enable debugging for sent MVRP packets on Ethernet 1/1.
<Sysname> debugging mvrp packet send interface ethernet 1/1
*Mar 31 17:23:59:860 2011 Sysname MVRP/7/MVRP_DEBUG: PACKET.Ethernet1/1.TX:
// MVRP sent packets through Ethernet 1/1.
VLAN Attribute = JoinIn, VLAN ID = 1.
// The VLAN ID was 1 and the attribute value was JoinIn.
debugging mvrp state
Use debugging mvrp state interface to enable MVRP state debugging for a VLAN on an interface.
Use undo debugging mvrp state to restore the default.
Syntax
debugging mvrp state interface interface-type interface-number vlan vlan-id
undo debugging mvrp state interface interface-type interface-number vlan vlan-id
Default
MVRP state debugging is disabled on an interface.
Views
User view
Default command level
1: Monitor level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
Table 2 describes output fields and messages for the debugging mvrp state command.
Table 84 Output from the debugging mvrp state command
Field
Description
AtrID
VLAN attribute ID, in the range of the minimum VLAN
ID to the maximum VLAN ID that the system supports.
109