HP Comware 5 Debug Manual Vol 3

NAT-PT debugging commands
debugging natpt
Use debugging natpt to enable NAT-PT debugging.
Use undo debugging natpt to disable NAT-PT debugging.
Syntax
debugging natpt { alg | all | event | packet } [ interface interface-type interface-number ]
undo debugging natpt { alg | all | event | packet } [ interface interface-type interface-number ]
Default
NAT-PT debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
alg: Specifies the application layer gateway (ALG) debugging.
all: Specifies all types of debugging.
event: Specifies the event debugging.
packet: Specifies the packet debugging.
interface interface-type interface-number: Specifies an interface by its type and number.
Examples
Figure 1 Network diagram
•
On single-core devices:
IPv4 host IPv6 host
IPv4 network IPv6 network
Device
Eth1/2
3.3.3.2
/24
Eth1/1
1000::2/64
3.3.3.1/24 1000::1/64
natpt address-group 1 5.1.1.1 5.1.1.20
natpt prefix 1001::
natpt v6bound dynamic prefix 1001
:: address-group 1 no-pat
interface Ethernet1/2
ip address 3.3.3.2 255.255.255.0
natpt enable
interface Ethernet1/1
ipv6 address 1000::2 64
natpt enable
118