HP Comware 5 Debug Manual Vol 3

Table 8 describes output fields and messages for the debugging ntp-service selection command.
Table 101 Output from the debugging ntp-service selection command
Field
Description
nlist: string Number of the candidate clocks in candidate clock list.
allow: string Number of surviving candidates.
found: string Number of discarded candidates.
low: string Lower value of the sample offset.
high: string Upper value of the sample offset.
candidate: string IP address of a candidate clock.
cdist: string Root distance of a candidate clock.
disp: string Dispersion of a candidate clock.
survivor: string IP address of the candidate clock survived in a check.
offset: string Offset of the candidate clock survived in a check.
cdist: string Dispersion of the candidate clock survived in a check.
syspeer: string IP address of the clock selected by the system.
offset: string Offset of the clock selected by the system.
Root-distance Synchronization distance.
Max root-distance
Maximum synchronization distance selected by the clock
source.
SYSPOLL System polling interval.
Table 9 describes output fields and messages for the debugging ntp-service validity command.
Table 102 Output from the debugging ntp-service validity command
Field
Description
NTP: packet from SourceIPAddr, TestResult
validity tests TestCode
• SourceIPAddr—Source IP address of the packet.
• TestResult—Test result, successful or failed.
• TestCode—Code of the object to be tested.
Code and its meaning of the object to be tested:
• 0x0001—Duplicate information.
• 0x0002—False information.
• 0x0004—Unsynchronized information.
• 0x0008—Peer delay/skew dispersion.
• 0x0010—Peer authentication failure.
• 0x0020—Unsynchronized peer clock.
• 0x0040—Peer stratum level exceeds the highest value.
• 0x0080—Root delay/dispersion exceeds the highest
value.
• 0x0100—No authentication on the peer.
• 0x0200—Access denied.
137