HP Comware 5 Debug Manual Vol 3

OAA debugging command
debugging oaa remote-interface
Use debugging oaa remote-interface to enable debugging for the OAA remote interface management
module.
Use undo debugging oaa remote-interface to disable debugging for the OAA remote interface
management module.
Syntax
debugging oaa remote-interface { all | error | event }
undo debugging oaa remote-interface { all | error | event }
Default
Debugging is disabled for the OAA remote interface management module.
Views
User view
Default command level
1: Monitor level
Parameters
all: All types of debugging for the OAA remote interface management module.
error: Error debugging for the OAA remote interface management module.
event: Event debugging for the OAA remote interface management module.
Examples
# Enable debugging for the remote interface management module. The output in this example was
created when the following conditions exist:
•
OAA remote interface management is configured on the client.
•
SNMP client is configured to communicate with the SNMP server.
•
Remote interface management is enabled.
•
The interface information is added to the dynamic remote interface table.
•
The Refresh button on the remote interface management page is clicked.
<Sysname> debugging oaa remote-interface all
*Mar 20 14:50:50:313 2008 Sysname RMIF/7/DEBUG_RMIF_EVENT:
Update snapshot remote-interface table.
// The snapshot remote interface table was updated.
139