HP Comware 5 Debug Manual Vol 3

OSPF 1 restarted OOB Progress timer for neighbor 150.1.1.2.
OSPF 1 deleted OOB Progress timer for neighbor 150.1.1.2.
OSPF 1 Gr Wait Timeout timer fired.
OSPF 1 deleted GR wait timer.
OSPF 1 deleted GR Interval timer.
OSPF 1 GR Completed for OSPF Router
// The device completed the GR.
OSPF 1 notified RM that OSPF process left GR.
RM notified that all protocol left GR.
OSPF 1 started flushing STALE LSA after all protocol left GR.
// OSPF started to flush stale LSAs after all the protocol exited GR.
OSPF 1: Flush Stale Area LSAs
OSPF 1: Start Flush Stale ASE + NSSA LSAs
OSPF 1: End Flush Stale ASE + NSSA LSAs
// Procedure of adjacency synchronization during GR.
debugging ospf hot-standby
Use debugging ospf hot-standby to enable hot-standby debugging for OSPF.
Use undo debugging ospf hot-standby to disable hot-standby debugging for OSPF.
Syntax
debugging ospf [ process-id ] hot-standby
undo debugging ospf [ process-id ] hot-standby
Default
OSPF hot-standby debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
process-id: Specifies an OSPF process by its ID, in the range of 1 to 65535.
Usage guidelines
If no process ID is specified, the hot-standby debugging information of all the OSPF processes will be
displayed.
Table 3 describes output fields and messages for the debugging ospf hot-standby command.
Table 105 Output from the debugging ospf hot-standby command
Field
Description
OSPF HSB Bkp: Instance ID: instance-id Process ID:
process-id
OSPF backed up the OSPF process data under the
specified instance.
• instance-id—OSPF instance ID.
• process-id—OSPF process ID.
143