HP Comware 5 Debug Manual Vol 3

Examples
# Enable MPLS-TE debugging for OSPF on Router A. The output in this example was created when the
following conditions exist:
•
Router A is configured with MPLS TE, OSPF, and LDP. Loopback 0 is created on Router A, with an
I P a d d r e s s o f 1.1.1.1 / 32. E thernet 1/0 (150.1.1.1/24) on Router A is connected to Ethernet 1/0
(150.1.1.2/24) on Router B over a broadcast network. On Router A:
 OSPF process 1 is created and is enabled with Opaque.
 Area 0 is created in OSPF process 1 and is enabled with TE.
 Ethernet 1/0 is enabled with OSPF and is configured to belong to area 0.
•
Router B is also configured with MPLS TE, CSPF, and LDP. Loopback 0 is created on Router B, with
an IP address of 2.2.2.2/32. On Router B:
 OSPF process 1 is created and is enabled with Opaque.
 Area 0 is created in OSPF process 1 and is enabled with TE.
 Ethernet 1/0 is enabled with OSPF and is configured to belong to area 0.
•
A TE tunnel interface is created on Router A, with an IP address of 6.1.1.1/24. The TE tunnel interface
runs MPLS TE and the destination is 2.2.2.2.
<RouterA> debugging ospf 1 mpls-te
150.1.1.2(Ethernet1/1) from Loading to Full
*Dec 20 15:01:37:86 2006 RouterA RM/6/RMDEBUG:OSPF TE
NSM_LoadingDone: LOADING DONE
*Dec 20 15:01:37:86 2006 RouterA RM/6/RMDEBUG:OSPF TE
HandleNeighborStateChg: BROADCAST
*Dec 20 15:01:37:86 2006 RouterA RM/6/RMDEBUG:OSPF TE
GetBroadCastNewGenNbr: Nbr DR, NbrIp = 2.2.2.2
*Dec 20 15:01:37:86 2006 RouterA RM/6/RMDEBUG:OSPF TE
GetBroadCastNewGenNbr: SUCCESS, MultiCastTeNbrID = 2.2.2.2
*Dec 20 15:01:37:86 2006 RouterA RM/6/RMDEBUG:OSPF TE
Received Link Info from RM
Process : 1
Area : 0.0.0.0
Link Type : 4
TE Metric : 0
Max BW : 0
Max Resv BW : 0
Admin Grp : 0
Received Network LSA by OSPF TE
Process ID : 1
Area ID : 0.0.0.0
Link Id : 150.1.1.2
Attached Rtr Count : 2
Advtg Router ID : 2.2.2.2
*Dec 20 15:01:37:86 2006 RouterA RM/6/RMDEBUG:OSPF TE
Send Network LSA to CSPF SUCCESS
Process ID : 1
150