HP Comware 5 Debug Manual Vol 3

Field
Description
FULL SPF ASE Begin at bucket bucket-num
Full ASE SPF calculation began at bucket bucket-num
in the Hash table.
FULL SPF ASE Stop at bucket bucket-num
Full ASE SPF calculation stopped at bucket bucket-num
in the Hash table.
INCR SPF ASE Begin Incremental ASE SPF began.
INCR SPF ASE End Incremental ASE SPF ended.
LSA ID inconsistent with netmas. LSID: ls-id, Netmask:
net-mask
ASE LSA ID and network mask are inconsistent.
MaxAge and No associated route, flush and delete
ASE LSA
Flush or delete the ASE LSAs that are aged out or have
no associated routes.
ASE LSA cost is infinity, don't calculate ASE LSA cost is infinite. It will not be calculated.
ASE net route, dest-id /mask-len,Inherit backup
nexthop
In FRR auto-mode, the routes of the ASE type inherit the
backup next hop of the following routes:
• Router type routes of the corresponding advertiser.
• Network type routes corresponding to the
forwarding address.
Parameter description:
• dest-id—Destination IP address.
• mask-len—Mask length.
ASE net route, dest-id /mask-len, nh next-hop,bnh
backup-next-hop ,attr-list
In FRR auto-mode, the result of calculating the backup
next hop for routes of the ASE type is listed.
• dest-id—Destination IP address.
• mask-len—Mask length.
• next-hop—Next hop address.
• backup-next-hop—Backup next hop address.
• attr-list—List to which the route belongs. The value
can be link (link protection), node (node
protection), or primary (primary next hop).
Examples
# Enable debugging for OSPF job scheduling. The output in this example was created when the
following conditions exist:
•
Ethernet1/0 (3.3.3.2/24) on Router B is connected to Ethernet1/0 (3.3.3.1/24) on Router A over
a broadcast network.
•
Ethernet1/1 (4.4.4.1/24) on Router B is connected to Ethernet1/0 (4.4.4.2/24) on Router C over
a broadcast network.
•
OSPF process 1 is created on Router B. Area 0 and area 1 are created in OSPF process 1. OSPF
is enabled on Ethernet 1/0, which is configured to belong to area 0. OSPF is enabled on Ethernet
1/1, which is configured to belong to area 1.
•
OSPF process 1 is created on Router A. Area 0 is created in OSPF process 1. OSPF is enabled on
Ethernet 1/0, which is configured to belong to area 0.
•
OSPF process 1 is created on Router C. Area 1 is created in OSPF process 1. OSPF is enabled on
Ethernet 1/0, which is configured to belong to area 1.
•
On Router A, enable FRR to automatically calculate a backup next hop.
168