HP Comware 5 Debug Manual Vol 3

Table 113 Output from the debugging ospfv3 event bfd command
Field
Description
Message Type XXXX
Type of message that OSPF uses to notify information
to BFD, including create session and delete session.
Connect Type direct-connect
The connection type of the BFD session is direct
connection.
Src IP Address X::X Source IPv6 address.
Dst IP Address X::X Destination IPv6 address.
Examples
# Enable ASBR event debugging on Router A. The output in this example was created when the following
conditions exist:
•
Router A is connected to Router B through Ethernet 1/0.
•
OSPFv3 process 1 is created on Router A. OSPFv3 is enabled on Ethernet 1/0.
•
OSPFv3 process 1 is created on Router B. OSPFv3 is enabled on the corresponding interface.
•
Router A and Router B are configured to belong to area 0. On Router A, static route redistribution
is configured and then canceled.
<Sysname> debugging ospfv3 event asbr
*0.2383219 Sysname RM/6/RMDEBUG:OSPFv3 ROUTER: change status to non-ASBR
// The router status changed from ASBR to non-ASBR.
*0.2649563 Sysname RM/6/RMDEBUG:OSPFv3 ROUTER: change status to ASBR
// The router status changed from non-ASBR to ASBR.
debugging ospfv3 graceful-restart
Use debugging ospfv3 graceful-restart to enable OSPFv3 GR debugging.
Use undo debugging ospfv3 graceful-restart to disable OSPFv3 GR debugging.
Syntax
debugging ospfv3 graceful-restart
undo debugging ospfv3 graceful-restart
Default
OSPFv3 GR debugging is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 3 describes output fields and messages for the debugging ospfv3 graceful-restart command.
179