HP Comware 5 Debug Manual Vol 3

a. Field
b. Description
o.
pfDRV_MINM_SetUplink is NULL
p.
Configuring the uplink
port is not supported.
q.
pfDRV_MINM_SetReEncapsulation is NULL
r.
Configuring the
re-encapsulation
information is not
supported.
Table 3 describes the output fields and messages for the debugging minm packet command.
Table 5 Output from the debugging minm packet command
a. Field
b. Description
c.
Receive MAC-in-MAC
frame from IFname
d.
MINM received MAC-in-MAC frames
on port IFname.
e.
B-DA
f.
Destination B-MAC address.
g.
B-SA
h.
Source B-MAC address.
i.
BTAG TPID
j.
BTAG type, which is fixed to 0x88a8.
k.
ITAG TPID
l.
ITAG type, which is fixed to 0x88e7.
m.
C-DA
n.
Destination C-MAC address.
o.
C-SA
p.
Source C-MAC address.
Examples
# Enable MAC-in-MAC error debugging. Output similar to the following example is generated when you
configure the uplink port and downlink port for MAC-in-MAC.
<Sysname> debugging minm error
*Oct 24 14:23:58:531 2009 Sysname MINM/7/Error: This packet is not received from BVLAN
1.
*Oct 24 14:23:58:531 2009 Sysname MINM/7/Error: Failed to learn BMAC.
// An uplink port in B-VLAN 1 received MAC-in-MAC frames from B-VLAN 20, and B-MAC learning
failed.
*Oct 24 14:27:16:968 2009 Sysname MINM/7/Error: The ISID of this packet is not configured
*Oct 24 14:27:16:968 2009 Sysname MINM/7/Error: Failed to learn BMAC.
// The I-SID of the MAC-in-MAC frame received was not as configured, and B-MAC learning failed.
# Enable MAC-in-MAC event debugging. Output similar to the following example is generated when
you configure the uplink port and downlink port for MAC-in-MAC.
<Sysname> debugging minm event
*Oct 24 14:34:02:828 2009 Sysname MINM/7/Event: Succeeded in sending IPC to slot ffffffff,
message type: 13.
// MINM succeeded in sending IPC message 13 (adding B-MAC) to the board in slot ffffffff.
*Oct 24 14:34:27:515 2009 Quidway MINM/7/Event: Succeeded in processing BMAC aging event
// MINM succeeded in aging the B-MAC entry.
*Oct 24 14:36:35:312 2009 Quidway MINM/7/Event: Succeeded in processing VSI event: 2
// MINM succeeded in processing VSI event 2 (shutting down VSI).
11