HP Comware 5 Debug Manual Vol 3

Field
Description
Lose the ASBSR election
The device lost the BSR election in the BSR
admin-scope region.
Lose the BSR election The device lost the BSR election.
locally scoped
Node-local or link-local scope.
RP changed The RP changed.
pending state The BSR changed to the pending state.
Update the BSR's state to elected The BSR changed to the elected state.
RPF Failure RPF check failed.
admin scope multicast address
Address in the admin-scope range.
Table 9 describes output fields and messages for the debugging pim state-refresh command.
Table 129 Output from the debugging pim state-refresh command
Field
Description
SRM
State refresh message.
Message truncated
Message length is invalid.
bad group address Incorrect group address.
invalid group mask length Incorrect group mask length.
Originator address Address of the state refresh message originator.
preference Preference field of the message.
metric Metric field of the message.
mask length Mask length field of the message.
ttl TTL value of the message.
prune indicator Prune indicator flag bit.
prune now Prune now indicator flag bit.
assert override Assert override flag bit.
Examples
The output in the following examples was created under the condition that PIM-DM or PIM-SM is
enabled:
# Enable debugging for inbound PIM assert messages for the public network.
<Sysname> debugging pim assert receive
*0.594609 Sysname PIM/7/ASSERT:(public net): PIM ver 2 AST receiving 30.1.1.2 ->224.0.0.13
on Vlan-interface30 (P012343)
*0.594609 Sysname PIM/7/ASSERT:(public net): For 229.0.0.1/32 from 100.1.1.11, rpt unset,
pref 10, metric 3 (P012351)
// PIM received a PIMv2 assert message from 3 0 .1.1. 2 to 224.0.0.13 on VLAN-interface 30.
# Enable debugging for outbound PIM assert messages for the public network.
<Sysname> debugging pim assert send
203