HP Comware 5 Debug Manual Vol 3

Field
Description
Failed to malloc for RPC message, when request
getting BlockMac number from a board.
The device failed to allocate memory for RPC
messages when it tried to obtain the number of
blocked MAC addresses.
Failed to malloc for RPC message, when request
getting BlockMac address from a board.
The device failed to allocate memory for RPC
messages when it tried to obtain blocked MAC
addresses.
MIB:OUITable proc block number is wrong.
MIB operation of OUI MAC entries. The number of
message blocks is incorrect.
MIB OUI set: self slot is in slave status, backup auto.
The port security module set the OUI table through a
MIB operation. The current MPU is a standby MPU
and backs up the OUIs automatically. (Distributed
devices/distributed IRF devices.)
The port security module set the OUI table through a
MIB operation. The current device is a subordinate
device and backs up the OUIs automatically.
(Centralized IRF devices.)
Table 3 describes output fields and messages for the debugging port-security event command.
Table 137 Output from the debugging port-security event command
Field
Description
InvalidAuth Invalid user.
Portsec SecureMAC table process begin...
The port security module began to add secure MAC
entries.
Configure IntrusionAction, the same as current config.
The Intrusion action to be configured is the same as the
action that is already configured.
Configure IntrusionAction, NoShutdown the port.
The port security module brought up the port, because
the port has been shut down by the intrusion
protection feature.
Configure IntrusionAction, port is not shutdown yet.
Intrusion protection action is configured and the port is
not shut down.
PortSec NoShutdown port... The port security module brought up the port.
PortSec receives a new SrcUnkown MAC but
portmode is not autolern, secure or userloginwithoui,
bypass it to macauth !
The port received a packet with an unknown source
MAC, but the port security mode is not autoLearn,
secure, or userLoginWithOUI. The port security
module starts to perform MAC authentication.
Get NULL pointer for delete count, alloc a memory
block for it...
The port security module prepares to remove the
secure MAC entries. Because the count pointer is null,
the device will allocate a memory block for it.
Security MAC distributed-backup is finished on slot
SlotID.
The port security module finished adding secure MAC
entries on the card in slot SlotID. (Distributed
devices/distributed IRF devices.)
The port security module finished adding secure MAC
entries on device SlotID. (Centralized IRF devices.)
227