HP Comware 5 Debug Manual Vol 3

Field
Description
Receive-Configure-Request(RCR+,RCR-)
A Configure-Request packet was received from the peer. RCR+
indicates that the request is acceptable and a Configure-Ack should
be sent back. RCR- indicates that the request is unacceptable, and
a Configure-Nak or Configure-Rej should be sent back.
Receive-Configure-Ack(RCA)
A valid Configure-Ack packet was received from the peer. The
packet is a positive response to a configuration request.
Receive-Configure-Nak/Rej(RCN)
A valid Configure-Nak/Rej packet was received from the peer. The
packet is a negative response to some or all requested
configuration options.
Receive-Terminate-Request(RTR)
A Terminate-Request packet was received, indicating that the peer
wanted to close the connection.
Receive-Terminate-Ack(RTA) A Terminate-Ack packet was received from the peer.
Receive-Unknown-Code(RUC) An unknown packet was received from the peer.
Receive-Code-Reject,
Receive-Protocol-Reject(RXJ+,RXJ-)
A Code-Reject or Protocol-Reject packet was received from the
peer. RXJ+ indicates that the rejected options are within the scope
of normal operation, so the rejection is acceptable. RXJ- indicates
that the rejected options are not acceptable, and link termination
will result.
Receive-Echo-Request An Echo-Request packet was received from the peer.
Receive-Echo-Reply An Echo-Reply packet was received from the peer.
Receive-Discard-Request(RXR) A Discard-Request packet was received from the peer.
Table 2 describes the output fields and messages for the debugging ppp ipcp command.
Table 147 Output from the debugging ppp ipcp command
Field
value
Field name Description
2 IP-Compression-Protocol The adopted IP compression protocol.
3 IP Address IP address negotiation.
129 Primary DNS Server Address PPP requested or allocated the primary DNS server.
130 Primary NBNS Server Address PPP requested or allocated the primary NBNS server.
131 Secondary DNS Server Address PPP requested or allocated a secondary DNS server.
132 Secondary NBNS Server Address PPP requested or allocated a secondary NBNS server.
Examples
# Enable LCP debugging. Output similar to the following example is generated when you enable PPP on
the two Serial interfaces connecting two devices and PPP negotiation starts between them.
<Sysname> debugging ppp lcp all
*0.784906 Sysname PPP/8/debug2:
PPP Event:
Serial2/0 LCP Open Event
state initial
// On interface Serial 2/0, the LCP state machine was opened and was in the initial state.
252