HP Comware 5 Debug Manual Vol 3

Table 157 Output from the debugging dar event command
Field
Description
Failed to write queue DAR failed to write information queue during traffic accounting.
Failed to trigger an event
DAR failed to trigger an event after writing information queue
successfully.
Failed to remove timer DAR failed to remove the timer for traffic accounting.
Session count has reached the upper limit
The number of sessions monitored by DAR reached the
configured upper limit.
Table 3 describes output fields and messages for the debugging dar packet command.
Table 158 Output from the debugging dar packet command
Field
Description
The head of the packet does not match The packet header did not match.
Examples
# Enable debugging for DAR events. When traffic accounting is enabled on Ethernet 1/0, output similar
to the following example is generated:
<Sysname> debugging dar event
*Apr 26 05:35:24:873 2007 Sysname DAR/7/DAR_Debug_Event: Ethernet1/0
Succeeded in starting protocol recognition!
// The protocol recognition function was enabled successfully on Ethernet 1/0.
# Enable debugging for DAR packets. Traffic accounting is enabled on Ethernet 1/0. Output similar to
the following example is generated when the IP address of Ethernet 1/0 is pinged from the device
connected to Ethernet 1/0.
<Sysname> debugging dar packet
*Apr 26 05:40:28:630 2007 Sysname DAR/7/DAR_Debug_Packet:
Succeeded in protocol recognition: icmp.
// ICMP packet was recognized successfully.
debugging p2p
Use debugging p2p to enable P2P debugging.
Use undo debugging p2p to disable P2P debugging.
Syntax
debugging p2p { all | error | event }
undo debugging p2p { all | error | event }
Default
P2P debugging is disabled.
Views
User view
263