HP Comware 5 Debug Manual Vol 3

Default
Debugging for packet matching in QoS is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 9 describes output fields and messages for the debugging qos match command.
Table 164 Output from the debugging qos match command
Field
Description
Match match-type were ignored for match-type did
not match the packet.
The match criterion based on match-type was ignored
because the match-type did not match the packet type.
Examples
# Enable debugging for packet matching in QoS on Router A. Output similar to the following example
is generated when an IP packet arrives at Router A under the following conditions:
•
The traffic from Router C travels by way of Router A to Router B.
•
A QoS policy is applied to the egress port (GE port) of Router A to match outgoing packets by
FR-DE.
<RouterA> debugging qos match
*Dec 17 14:05:31:150 2007 RouterA QOS/7/QOS_Debug:
QOS_Match: Match FR-DE were ignored for match-type did not match the packet.
// The FR-DE match criterion was ignored because the match-type FR-DE did not match the packet type.
debugging qos remark
Use debugging qos remark to enable debugging for packet re-marking in QoS.
Use undo debugging qos remark to disable debugging for packet re-marking in QoS.
Syntax
debugging qos remark
undo debugging qos remark
Default
Debugging for packet re-marking in QoS is disabled.
Views
User view
Default command level
1: Monitor level
Usage guidelines
Table 10 describes output fields and messages for the debugging qos remark command.
271