HP Comware 5 Debug Manual Vol 3

Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
Examples
# Enable brief RIP debugging on Router A. The output in this example was created when the following
conditions exist:
•
Router A is connected to Router B through Ethernet 1/1.
•
RIP is enabled on Router A and Router B.
<Sysname> debugging rip 1 brief
*Nov 24 15:28:22:814 2006 Sysname RM/6/RMDEBUG: RIP 1 : Sending v2 response on Ethernet1/1
from 40.0.0.2
// RIP process 1 sent a response packet of version 2 on Ethernet 1/1 from 40.0.0.2.
*Nov 24 15:28:34:868 2006 Sysname RM/6/RMDEBUG: RIP 1 : Receiving v2 response on Ethernet1/1
from 40.0.0.1
// RIP process 1 received a response packet of version 2 on Ethernet 1/1 from 40.0.0.1.
debugging rip event
Use debugging rip event to enable RIP event debugging.
Use undo debugging rip event to disable RIP event debugging.
Syntax
debugging rip process-id event
undo debugging rip process-id event
Default
RIP event debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
Usage guidelines
Table 1 describes output fields and messages for the debugging rip event command.
289