HP Comware 5 Debug Manual Vol 3

*Nov 24 15:45:45:537 2006 Sysname RM/6/RMDEBUG: Packet : vers 2, cmd request, length
8
// The version of the sent request packet is 2 and the packet length is 8 bytes.
*Nov 24 15:45:45:564 2006 Sysname RM/6/RMDEBUG: TRIP 1 : Receive response on Serial2/0
from 50.0.0.2
// TRIP process 1 received a response packet from 50.0.0.2 on Serial 2/0.
*Nov 24 15:45:45:564 2006 Sysname RM/6/RMDEBUG: Packet : vers 2, cmd response (FLUSH),
length 8, sequence num 0
// The version of the received response packet (with FLUSH) is 2. The packet length is 8 bytes and the
sequence number is 0.
*Nov 24 15:45:45:564 2006 Sysname RM/6/RMDEBUG: TRIP 1 : Sending acknowledgement on
interface Serial2/0 to 50.0.0.2
// TRIP process 1 sent an acknowledgement packet on Serial 2/0 to 50.0.0.2.
*Nov 24 15:45:45:564 2006 Sysname RM/6/RMDEBUG: Packet : vers 2, cmd acknowledgement
(FLUSH), length 8, sequence num 0
// The version of the sent acknowledgement packet (with FLUSH) is 2. The packet length is 8 bytes and
the sequence number is 0.
debugging rip receive
Use debugging rip receive to enable received RIP packet debugging.
Use undo debugging rip receive to disable received RIP packet debugging.
Syntax
debugging rip process-id receive [ interface interface-type interface-number ]
undo debugging rip process-id receive [ interface interface-type interface-number ]
Default
Received RIP packet debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
interface interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
Table 2 describes output fields and messages for the debugging rip receive command.
Table 172 Output from the debugging rip receive command
Field
Description
Authentication failure
Authentication failed because of an authentication
type mismatch or a non-minus RFC 2453 sequence
number.
293