HP Comware 5 Debug Manual Vol 3

•
Ethernet 1/1 of Router A is connected to Ethernet 1/1 of Router B.
•
RIPng is enabled on Ethernet 1/1 of Router A and on Ethernet 1/1 of Router B.
<Sysname> debugging ripng 1 brief
*Nov 22 21:17:37:662 2006 Sysname RM/6/RMDEBUG:RIPng 1 : Sending v1 response on Ethernet1/1
to FF02::9 with 2 RTEs
// RIPng process 1 sent a response packets of version 1 on Ethernet 1/1 to FF02::9 with two RTEs.
*Nov 22 21:17:40:390 2006 Sysname RM/6/RMDEBUG:RIPng 1 : Receiving v1 response on
Ethernet1/1 from FE80::200:5EFF:FE71:A706 with 2 RTEs
// RIPng process 1 received a response packet of version 1 on Ethernet 1/1 from
FE80::200:5EFF:FE71:A706 with two RTEs.
debugging ripng event
Use debugging ripng event to enable RIPng event debugging.
Use undo debugging ripng event to disable RIPng event debugging.
Syntax
debugging ripng process-id event
undo debugging ripng process-id event
Default
RIPng event debugging is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
process-id: Specifies a RIPng process by its ID, in the range of 1 to 65535.
Examples
# Enable RIPng event debugging on Router A. The output in this example was created when the following
conditions exist:
•
RIPng process 1 is created on Router A.
•
RIPng is enabled on Ethernet 1/1.
<Sysname> debugging ripng 1 event
[Sysname-Ethernet1/1] ripng 1 enable
*Nov 22 21:48:54:988 2006 Sysname RM/6/RMDEBUG:RIPng 1 : Adding Ethernet1/1 to Network
List
// RIPng process 1 was enabled on Ethernet 1/1.
*Nov 22 21:47:25:836 2006 Sysname RM/6/RMDEBUG:RIPng 1 : Triggered update sent
// RIPng process 1 sent a triggered update.
# Disable RIPng on Ethernet 1/1 of Router A.
[Sysname-Ethernet1/1] undo ripng enable
*Nov 22 21:50:46:270 2006 Sysname RM/6/RMDEBUG:RIPng 1 : Removing Ethernet1/1 from Network
List
299