HP Comware 5 Debug Manual Vol 3

Parameters
general: Specifies debugging for general RPR events, including protection state changes, miscabling
changes, and port UP/DOWN events.
ringlet-selection: Specifies debugging for RPR ringlet selection events.
interface interface-type interface-number: Specifies a port by its type and number.
Usage guidelines
Table 2 describes output fields and messages for the debugging rpr event command.
Table 176 Output from the debugging rpr event command
Field
Description
RPR_Event: On interface-type
interface-number, String1 ringlet
selection table was updated!
String2
A ringlet selection table was updated.
The String1 field specifies the updated ringlet selection table:
• default—Default ringlet selection table.
• shortest path—Shortest path ringlet selection table.
• overall—Overall ringlet selection table.
• VRRP—VRRP ringlet selection table.
• IPv6—IPv6 ringlet selection table.
• VLANTunnel—VLAN tunnel ringlet selection table.
• mac-learning—MAC learning ringlet selection table.
The String2 field specifies the updated contents:
• MAC: MAC_ADDR updated—MAC addresses.
• Begin update ShortestPath rs with Wrap mode—Began updating the
shortest path ringlet selection table in wrap mode.
• End update dynamic rs with Wrap mode—Ended updating the
dynamic ringlet selection table in wrap mode.
• Begin update ShortestPath rs with Steer mode—Began updating the
shortest path ringlet selection table in steer mode.
• End update dynamic rs with ShortestPath—Ended updating the
dynamic ringlet selection table with ShortestPath.
• Update String RS start—Started updating the ringlet selection table.
The String field can be default, shortest path, overall, VRRP, IPv6,
VLANTunnel, or mac-learning.
• Update String RS finished—Finished updating the ringlet selection
table. The String field can be default, shortest path, overall, VRRP, IPv6,
VLANTunnel, or mac-learning.
• Update RS start—Began to update the ringlet selection table.
• Update RS finished—Finished updating the ringlet selection table.
RPR_Event: On interface-type
interface-number, String
The String field indicates the event that occurred:
• TP content change flag is set.
• Successed to Start protocol.
• Begin to delete Ipv6 Mac Address: MAC_ADDR.
• Begin to add Ipv6 Mac Address: MAC_ADDR.
• End to add Ipv6 Mac Address: MAC_ADDR.
310