HP Comware 5 Debug Manual Vol 3

Field
Description
RPR_Event: On interface-type
interface-number, at String1 span,
String2
The String1 field indicates the direction (east or west)
The String2 field indicates the event that occurred:
• Interface up—An interface went up.
• Interface down—An interface went down.
• Mistake cable is occurred—Miscabling occurred.
• Protection status is changed—Protection state changed.
• MATE status is changed—The state of the MATE port changed.
Examples
# Enable debugging for RPR ringlet selection event debugging. The output in this example was created
when two stations form a closed RPR ring. When you remove the optical fiber to trigger protection on the
station and update the ringlet selection table, output similar to the following example is generated:
<Sysname> debugging rpr event ringlet-selection
*Jun 5 11:24:51:218 2007 Sysname RPR/7/EVT_RS:Slot=3;
RPR_Event: On RPR1, overall ringlet selection table was updated! Update overall RS start!
// On interface RPR1, the overall ringlet selection table was updated. RPR began to update the overall
ringlet selection table.
*Jun 5 11:24:51:889 2007 Sysname RPR/7/EVT_RS:Slot=3;
RPR_Event: On RPR1, overall ringlet selection table was updated! Update overall RS
finished!
// On interface RPR1, the overall ringlet selection table was updated. RPR ended the updating of the
overall ringlet selection table.
# Enable debugging for RPR ringlet selection event debugging on interface RPR1. The output in this
example was created when two stations form a closed RPR ring. When you configure FS in the west
direction of a station to change the topology and update the ringlet selection table, output similar to the
following example is generated:
<Sysname> debugging rpr event ringlet-selection int rpr 1
*Jun 5 11:28:49:170 2007 Sysname RPR/7/EVT_RS:Slot=5;
RPR_Event: On RPR1, dynamic ringlet selection table was updated! Update shortest path
RS start!
// On interface RPR1, the dynamic ringlet selection table was updated. RPR began the updating of the
shortest path ringlet selection table.
*Jun 5 11:28:49:359 2007 Sysname RPR/7/EVT_RS:Slot=5;
RPR_Event: On RPR1, dynamic ringlet selection table was updated! Update shortest path
RS finished!
// On interface RPR1, the dynamic ringlet selection table was updated. RPR finished the updating of the
shortest path ringlet selection table.
# Enable RPR general event debugging. The output in this example was created when two stations form
a closed RPR ring. When you shut down the west physical port, output similar to the following example
is generated:
<Sysname> debugging rpr event general
*Jun 5 11:34:22:360 2007 Sysname RPR/7/EVT_SPAN:
RPR_Event: On RPR1, at west span, Interface down.
// On interface RPR1, the west physical port went down.
311