HP Comware 5 Debug Manual Vol 3

Tuple5: 192.168.0.92/8-->192.168.1.58/3840(ICMP)
// The service module NAT added extended information to the session successfully.
debugging session packet-process
Use debugging session packet-process to enable debugging for packet processing of session
management.
Use undo debugging session packet-process to disable debugging for packet processing of session
management.
Syntax
debugging session packet-process
undo debugging session packet-process
Default
Debugging for packet processing of session management is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
packet-process: Specifies debugging for packet processing.
Examples
# Enable debugging for packet processing on the device with the security module enabled. Output
similar to the following example is generated when a checksum error packet is sent to the device under
the condition that the device is enabled with checksum verification.
<Sysname> debugging session packet-process
<Sysname> system-view
[Sysname] session checksum all
*Mar 26 08:50:24:568 2007 Sysname DPSESSIO/7/PKTPROC:
Tuple3: 192.168.1.58-->192.168.1.11(TCP)
Received: checksum error packet
// The packet process received a checksum error TCP packet.
*Mar 26 08:57:24:896 2007 Sysname DPSESSIO/7/PKTPROC:
Tuple3: 192.168.0.21-->192.168.1.89(TCP)
ERROR: unknown ICMP error control packet
// The packet process received a TCP ICMP error control packet.
debugging session relation
Use debugging session relation to enable debugging for session relation table of session management.
Use undo debugging session relation to disable debugging for session relation table of session
management.
334