HP Comware 5 Debug Manual Vol 3

Field
Description
DECODE_WARNING
Warning-level debugging information generated
during the SNMP request decoding process.
DECODE_ERROR
Error-level debugging information generated during
the SNMP request decoding process.
Table 5 describes output fields and messages for the debugging snmp agent process txrx command.
Table 201 Output from the debugging snmp agent process txrx command
Field
Description
TXRX_INFO
Info-level debugging information generated when SNMP
messages were being sent and received.
TXRX_WARNING
Warning-level debugging information generated when
SNMP messages were being sent and received.
TXRX_ERROR
Error-level debugging information generated when SNMP
messages were being sent and received.
failed to set IPv6 socket option while creating
IPv6 socket (errCode: error-code)
This IPv6 socket option determines whether the IP address
and port number used by this socket can be bound with
another socket.
failed to set IPv4 socket option while receiving
PDU through IPv4 socket
This IPv4 socket option determines whether the destination IP
address can be parsed out from the received packet.
Table 6 describes output fields and messages for the debugging snmp agent process stack command.
Table 202 Output from the debugging snmp agent process stack command
Field
Description
STACK_INFO
Info-level debugging information generated when the SNMP
request PDU is being handled.
STACK_WARNING
Warning-level debugging information generated when the
SNMP request PDU is being handled.
STACK_ERROR
Error-level debugging information generated when the SNMP
request PDU is being handled.
create CFG message for get-request and
parse CFG message for response
CFG is an abbreviation of configuration.
get value from CFG message (CMO type:
CMO-type)
CMO is an abbreviation of Configuration Management
Object.
parameter number parameter-number from
CFG message less than index number
index-number
Number of parameters from the CFG message is smaller than
the number of parameters from the indexes.
The number of users who can set reaches the
limit.
Number of users who can perform the set operation has
reached the upper limit.
Examples
# Enable information center debugging and info-level SNMP PDU debugging on the device. Output
similar to the following example is generated when network management software is used to perform a
Get operation on object sysUpTime under these conditions:
396