HP Comware 5 Debug Manual Vol 3

Syntax
debugging stp global-error
undo debugging stp global-error
Default
STP global error debugging is disabled.
Views
User view
Default command level
2: System level
Usage guidelines
Table 3 describes output fields and messages for the debugging stp global-error command.
Table 207 Output from the debugging stp global-error command
Field
Description
Port PortID(PortName) received BPDU packet
is error for String
Port PortID(PortName) received an error BPDU.
The String argument specifies the reason for the error.
Port PortID(PortName) received error BPDU
and discarded it
Port PortID(PortName) received and dropped an error BPDU.
The protocol type ID is wrong Incorrect protocol type ID.
The protocol version ID is wrong
Incorrect protocol version ID. Correct protocol version ID:
• 0—STP.
• 2—RSTP.
• 3—MST P.
Creating mbuffer failed MSTP failed to create the buffer.
P/V semaphore error Semaphore operation failed.
Set STP String error
MSTP failed to set the STP state to the driver.
The String argument specifies the STP state, which is enable or
disable.
Creating responsive message for
configuration failed
MSTP failed to create a configuration response message.
Port PortID is inexistent Port PortID does not exist.
Active region configuration error MSTP failed to activate region configuration.
Set instance InstanceID's port
PortID(PortName) STP state String error
Set VLAN VLANID's port PortID(PortName)
STP state String error
The state String of port PortID(PortName) on MSTI InstanceID
or VLAN VLANID was set incorrectly.
The possible values of the String argument are:
• discarding.
• learning,
• forwarding.
406