HP Comware 5 Debug Manual Vol 3

*Nov 7 17:06:08:412 2006 Sysname MCS/7/ipcsend:Inform other boards: this board is a new
router board. (G143331)
// MLD snooping sent an IPC packet.
# Enable MLD snooping packet debugging. When MLD snooping is enabled on the device, output
similar to the following example is generated:
<Sysname> debugging mld-snooping packet
*Nov 7 09:37:21:174 2006 Sysname MCS/7/packet:Received MLDv2 report packet for destination
address FF02::16 from port Eth1/1 on vlan 2. (G213068)
// MLD snooping received an MLD report on Ethernet 1/1 in VLAN 2.
*Nov 7 09:37:54:174 2006 Sysname MCS/7/packet:Send the packet to port Eth1/1 of vlan
2,which source address is FE80::1 and destination address is FF02::16. (G261104)
// MLD snooping sent an MLD message with the source address FE80::1 and the destination address
FF02::16 out of Ethernet 1/1 in VLAN 2.
# Enable MLD snooping timer debugging. When MLD snooping is enabled on the device, output similar
to the following example is generated:
<Sysname> debugging mld-snooping timer
*Nov 7 17:06:08:412 2006 Sysname MCS/7/timer:Create router port aging timer, 260 seconds,
for port: Eth1/1, vlan: 2. (G141414)
// MLD snooping created a router port aging timer on Ethernet 1/1 in VLAN 2 and set the aging timer
to 260 seconds.
*Nov 7 17:06:54:712 2006 Sysname MCS/7/timer:Create query respond timer of group FF02::16,
2000 milliseconds. (G153777)\
// MLD snooping created a query response timer for the IPv6 multicast group FF02::16 and set the time
interval to 2 seconds.
35