HP Comware 5 Debug Manual Vol 3

Modem debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging modem
Use debugging modem to enable modem debugging.
Use undo debugging modem to disable modem debugging.
Syntax
debugging modem [ interface interface-type interface-number ]
undo debugging modem [ interface interface-type interface-number ]
Views
User view
Default command level
1: Monitor level
Parameters
interface-type interface-number: Interface type and interface number.
Usage guidelines
Table 1 describes output fields and messages for the debugging modem command.
Table 27 Output from the debugging modem command
Field
Description
AT AT command.
OK Connection was established successfully.
ATDT AT command used to dial a number.
ATA
AT command used to answer a call without waiting
for a ring.
+++ Quit command.
IDLE Idle state.
CONNECT Connected state.
ACTIVE Active state.
DISCONNECT Disconnect state.
BUSY Line busy.
NO CARRIER No carrier signal was detected.
MDM_LINE_MODEM_NO Both answering calls and placing calls were disabled.
MDM_LINE_MODEM_IN Answering calls was enabled.
36