HP Comware 5 Debug Manual Vol 3

debugging dhbk service
Use debugging dhbk service to enable stateful failover service debugging.
Use undo debugging dhbk service to disable stateful failover service debugging.
Syntax
debugging dhbk service { all | error | event | fsm | info }
undo debugging dhbk service { all | error | event | fsm | info }
Default
Stateful failover service debugging is disabled.
Views
User view
Parameters
all: Specifies all types of stateful failover service debugging.
error: Specifies stateful failover service error debugging.
event: Specifies stateful failover service event debugging.
fsm: Specifies stateful failover service FSM debugging.
info: Specifies stateful failover service object information debugging.
Usage guidelines
Table 4 describes output fields and messages for the debugging dhbk service event command.
Table 223 Output from the debugging dhbk service event command
Field
Description
Response: request
DHBK responded to the message from the management module:
• Start sending or receiving backup information.
• Stop sending or receiving backup information.
Received: notify
DHBK received the message from the management module:
• Synchronous event.
• Non-synchronous event.
Backup objects: backup-object
Backup objects:
• Common session.
• Father session.
• Force session.
• Session relation-table.
• NAT attached information.
• ALG attached information.
• Blacklist.
• Aging message.
• LB (load balancing) session.
• LB persistence entry backup succeeded.
• Received synchronization event when backing up LB session.
•
Received stop-synchronization event when backing up LB session.
435