HP Comware 5 Debug Manual Vol 3

Field
Description
L7 LB session restored. Redirect: Redirect-info, Seq
num adjust: Seqnum-adjust, MSS: MSS-info, Request
Sequence Info (Init: init-info, Adjust len: adjust-len,
Next Adjust len: nextadjust-len), Response Sequence
Info (Init: init-info, Adjust len: adjust-len, Next Adjust
len: nextadjust-len).
LB restoration information. L7 LB session restored:
• Redirect-info—Redirection identifier.
• Seqnum-adjust—Sequence number adjustment
identifier.
• MSS-info—MSS information.
• Request Sequence Info—Request sequence number
information:
 init-info—Initial information.
 adjust-len—Adjusted length.
 nextadjust-len—Next adjusted length.
• Response Sequence Info—Response sequence
number information.
LB LastHop backed up. LastHopFlag: lastHop-flag,
SubLastHopFlag: sublasthop-flag, Interface:
interface-name, MAC: MAC-address.
LB backup information. Last hop backup succeeded:
• lastHop-flag—Last hop identifier.
• sublasthop-flag—Sub session last hop identifier.
• interface-name—Interface name.
• MAC-address—MAC address.
LB LastHop restored. LastHopFlag: lastHop-flag,
SubLastHopFlag: sublasthop-flag, Interface:
interface-name, MAC: MAC-address.
LB restoration information. Last hop restored:
• lastHop-flag—Last hop identifier.
• sublasthop-flag—Sub session last hop identifier.
• interface-name—Interface name.
•
MAC-address—MAC address.
LB persist backed up.
Virtual service ID: VS-ID, Persistence Value:
persist-value.
LB persistent backup succeeded:
• VS-ID—Virtual service ID.
• persist-value—Persistent value.
Examples
# Enable stateful failover service event debugging.
<Sysname> debugging dhbk service event
*July 26 09:40:56:763 2007 Sysname DPDHBKS/7/debug:
dhbk service event:
Respond: start sending or receiving backup info.
// Stateful failover started sending or receiving backup data.
# Enable stateful failover service object information debugging. Output similar to the following example
is generated when the client at 10.1.1.11 accesses the FTP server at 100.0.0.100 through FW1 under the
following conditions:
•
The same one-to-one NAT entry is configured on FW1 and FW2.
•
The internal IP address 10.1.1.11 is mapped to the public IP address 100.0.0.50.
•
FW1 and FW2 are in Synchronize state.
<Sysname> debugging dhbk service info
*Apr 26 12:46:20:463 2007 Sysname SESS_DP/7/TABLE:
dhbk service info:
Session information:
ReqTuple5: 10.1.1.11/2798-->100.0.0.100/21(TCP)
RespTuple5: 100.0.0.100/21-->100.0.0.50/2798(TCP)
440