HP Comware 5 Debug Manual Vol 3

UDP helper debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging udp-helper
Use debugging udp-helper to enable UDP helper debugging.
Use undo debugging udp-helper to disable UDP helper debugging.
Syntax
debugging udp-helper { event | packet [ receive | send ] }
undo debugging udp-helper { event | packet [ receive | send ] }
Default
UDP helper debugging is disabled.
Views
User view
Default command level
2: System level
Parameters
event: Specifies UDP helper event debugging.
packet: Specifies UDP helper packet debugging.
receive: Specifies UDP helper debugging for received packets.
send: Specifies UDP helper debugging for sent packets.
Usage guidelines
Table 1 describes output fields and messages for the debugging udp-helper event command.
Table 236 Output from the debugging udp-helper event command
Field
Description
MBUF copy failed UDP helper failed to copy packets.
Prompt: TTL Exceed! TTL expired.
Dest Ip(Num) is not routable or the packet
is from the device itself.
No operation was performed because the outgoing interface did
not exist or the packet was sent from the local device.
Pointer of the route table outer interface is
NULL!
Outgoing interface pointer of the route entry is NULL.
Getting self Unit ID failed UDP helper failed to get the ID of the local unit.
Prompt: Convert xid to saved xid UDP helper converted XID and saved it.
459