HP Comware 5 Debug Manual Vol 3

Field
Description
send VICTL_COM_EC_ON to dsp
DSP was notified to enable the echo cancellation (EC)
function.
send VICTL_COM_EC_OFF to dsp DSP was notified to disable the EC function.
send VICTL_COM_VAD_ON to dsp DSP was notified to enable VAD.
send VICTL_COM_VAD_OFF to dsp DSP was notified to disable VAD.
relay( Number of Fax Data)temporarily saved fax
packets to fofr!
Buffered fax packets were sent to the FOFR module for
processing.
get modulation-off again
Modulation-off signals were received from the
network side during fax data receiving.
unrecovered, dis card packet
Two consecutive T.30 fax packets were lost, and the
T.30 signaling frame was discarded.
set unrecovered flag
The corresponding flag was set to True when two
consecutive T.30 fax packets were lost.
need not send tone message
No fax tone was sent to the network side because the
send queue length was greater than 0.
send tone message Fax tones were sent to the network side.
create NoCarrier automatically! No carrier signal.
send preamble ok A preamble was sent.
send last tone message to net The last fax tone was sent to the network side.
send last Modulation-On to net
The last modulation-on signal was sent to the network
side.
send last Modulation-Off to net
The last modulation-off signal was sent to the network
side.
send last HDLC-CRC to net
The last HDLC CRC packet was sent to the network
side.
receive single freq from net
A single frequency tone was received from the
network side.
unwanted tone message
A single frequency tone was considered to be an
unwanted signal.
receive preamble from net !
moduration type = fax_moduration type value
A preamble was received from the network side.
modulation type refers to the fax modulation type.
no any preamble! No preamble.
fax protocal not support! The fax protocol was not supported.
limit rate unchanged There was no need to change the fax rate.
the callee's number is callee number Received callee number.
Table 9 describes output fields and messages for the debugging voice vofr timer command.
Table 248 Output from the debugging voice vofr timer command
Field
Description
switch timer started! The switch timer was started.
474