HP Comware 5 Debug Manual Vol 3

MPLS L2VPN debugging commands
The output description tables in this document only contain fields and messages that require an
explanation.
debugging mpls l2vpn
Use debugging mpls l2vpn to enable debugging for MPLS L2VPN.
Use undo debugging mpls l2vpn to disable debugging for MPLS L2VPN.
Syntax
debugging mpls l2vpn { advertisement | all | connections | error | event | hsb }
undo debugging mpls l2vpn { advertisement | all | connections | error | event | hsb }
Default
Debugging for MPLS L2VPN is disabled.
Views
User view
Default command level
1: Monitor level
Parameters
advertisement: Specifies debugging for advertisement events.
all: Specifies debugging for all events.
connections: Specifies debugging for connection events.
error: Specifies debugging for error events.
event: Specifies debugging for bottom layer events.
hsb: Specifies debugging for hot standby events.
Usage guidelines
Table 1 describes output fields and messages for the debugging mpls l2vpn advertisement command.
Table 28 Output from the debugging mpls l2vpn advertisement command
Field
Description
peer pe ip address IP address of the specified peer PE.
fec element type FEC type. The value is 128.
c-Bit
Control bit. 1 means enabled, and 0 means not
enabled.
group id
Used to remove VC information with the same group
ID in batch.
vsi type VSI access type.
41