HP Comware 5 Debug Manual Vol 3

Usage guidelines
For the completeness of debugging information, H3C recommends that you enable debugging mpls
rsvp-te tunnel-id for each type of RSVP-TE debugging except for debugging mpls rsvp-te all.
Table 1 describes output fields and messages for the debugging mpls rsvp authentication command.
Table 47 Output from the debugging mpls rsvp authentication command
Field
Description
Local IfEntry number is x. The local RSVP-TE interface sequence number is X.
Table 2 describes output fields and messages for the debugging mpls rsvp error command.
Table 48 Output from the debugging mpls rsvp error command
Field
Description
Invalid IfIndex Invalid interface index.
IF Not Enbale Authenticate Authentication is not enabled on the interface.
Table 3 describes output fields and messages for the debugging mpls rsvp hello command.
Table 49 Output from the debugging mpls rsvp hello command
Field
Description
Nbr is lost, process Frr Nbr lost Neighbor was lost. Frr processed neighbor loss.
Table 4 describes output fields and messages for the debugging mpls rsvp hsb command.
Table 50 Output from the debugging mpls rsvp hsb command
Field
Description
AMB: Backup Global Data and send to HAC
Active MPU: Backed up the global data and sent it to
HAC.
SMB: Restore Global Data Standby MPU: Restored the global data.
SMB: RealTime Restore TCSB Data
Standby MPU: Restored the traffic control state block
(TCSB) data.
Table 5 describes output fields and messages for the debugging mpls rsvp main command.
Table 51 Output from the debugging mpls rsvp main command
Field
Description
RSVP GR process: RSVP NBR x.x.x.x restarting. RSVP GR process: RSVP neighbor xxx is restarting.
Table 6 describes output fields and messages for the debugging mpls rsvp path command.
Table 52 Output from the debugging mpls rsvp path command
Field
Description
Path mesg Received with Lih xxx for IfAddr xxx
MPLS TE received a path message with the logical
interface handle (LIH) of xxx from interface xxx.
65