HP Comware 5 Debug Manual Vol 3

MAC authentication debugging commands
The MAC authentication module name is identified as "MACAUTH" in debugging messages.
Some information in this chapter is device type specific. Devices in this chapter are categorized
depending on their IRF capability and support for interface cards that use independent processors for
forwarding traffic, as shown in Table 1.
Table 1 Device types
Device type
Interface cards with
on-card processors
IRF capability Examples
Distributed devices Yes
No
HP 6600 routers (except
for 6602)
Yes (in standalone mode)
HP 12500 switches
HP 10500 switches
Distributed IRF devices Yes Yes (in IRF mode)
HP 12500 switches
HP 10500 switches
Centralized devices No No
HP MSR routers
HP 6602 router
Centralized IRF devices No Yes
HP 5800 switches
HP 5500 switches
The output description tables in this document only contain fields and messages that require an
explanation.
debugging mac-authentication
Use debugging mac-authentication to enable MAC authentication debugging.
Use undo debugging mac-authentication to disable MAC authentication debugging.
Syntax
Centralized devices:
debugging mac-authentication event
undo debugging mac-authentication event
Distributed devices/centralized IRF devices:
debugging mac-authentication event [ slot slot-number ]
undo debugging mac-authentication event [ slot slot-number ]
Distributed IRF devices:
debugging mac-authentication event [ chassis chassis-number slot slot-number ]
undo debugging mac-authentication event [ chassis chassis-number slot slot-number ]
1