HP Comware 5 Debug Manual Vol 3

*Aug 25 09:35:45:790 2006 ar2 MSDP/7/EVENT:

(public net):11.11.11.11: TCP connection established (H12854)

// A TCP connection was established.

*Aug 25 09:35:45:790 2006 ar2 MSDP/7/EVENT:

(public net):11.11.11.11: Sending message to peer: keepalive (H101045)

// The device sent keepalive messages to the MSDP peer.

*Aug 25 09:35:45:790 2006 ar2 MSDP/7/EVENT:

(public net):11.11.11.11: Originating SA message for peer (H10859)

// The device sent SA messages (if any) to the MSDP peer.

# Enable debugging for MSDP messages on the public network. When MSDP is enabled, output similar

to the following example is generated:

<Sysname> debugging msdp packet

*Aug 25 09:39:07:162 2006 ar2 MSDP/7/PACKET:

(public net):11.11.11.11: Sending a 3-bytes message to peer (H17119)

// The device sent a three-byte message to the MSDP peer.

*Aug 25 09:39:07:162 2006 ar2 MSDP/7/PACKET:

(public net):11.11.11.11: Sending to peer success, 3-bytes sent (H17143)

// The device succeeded in sending the message to the MSDP peer.

*Aug 25 09:39:07:162 2006 ar2 MSDP/7/PACKET:

(public net):11.11.11.11: Received 3-bytes message 1 from peer (H13471)

// The MSDP peer received the three-byte message.

*Aug 25 09:39:07:162 2006 ar2 MSDP/7/PACKET:

(public net):11.11.11.11: KeepAlive TLV (H131441)

// This message is a keepalive message.

# Enable debugging for active sources of MSDP on the public network. When MSDP is enabled, output

similar to the following example is generated:

<Sysname> debugging msdp source-active

*Aug 25 09:52:08:924 2006 ar2 MSDP/7/SOURCE-ACTIVE:

(public net):11.11.11.11: Only one peer, passed RPF check (H132426)

// The SA message was received. The RPF check succeeded because only one MSDP peer exists.