HP Comware 5 Debug Manual Vol 3

MTR debugging commands

Enabling any debugging command in this chapter might affect system performance, especially when the

system is busy. Disable debugging after the debugging operation is complete.

debugging multiple-topology event

Use debugging multiple-topology event to enable topology event debugging.

Use undo debugging multiple-topology event to disable topology event debugging.

Syntax

debugging multiple-topology event

undo debugging multiple-topology event

Default

Topology event debugging is disabled.

Views

User view

Default command level

1: Monitor level

Examples

# Enable topology event debugging. When you create topology voice, output similar to the following

example is generated:

<Sysname> debugging multiple-topology event

[Sysname-address-family ipv4] multiple-topology voice

*Jul 20 11:44:17:282 2009 Sysname MT/7/MTDBG: Create topol:voice

debugging multiple-topology hsb

Use debugging multiple-topology hsb to enable topology hot backup debugging.

Use undo debugging multiple-topology hsb to disable topology hot backup debugging